Maintenance and Care of Rotary Drill Rig Reducers (Crane-Type)

Customers often ask about the correct way to maintain rotary drill rig reducers. In fact, proper maintenance is straightforward and mainly focuses on lubrication management and timely replacement of wear parts. Regular upkeep ensures stable performance, longer service life, and safer operation.

1. Regular Lubricating Oil Maintenance

Proper lubrication is the most critical factor in reducer maintenance.

First oil change: After initial operation, worm gear replacement, or 150–400 working hours

Routine interval: Every ≤ 4000 working hours thereafter

Inspection: Regularly check oil level and oil condition; replace immediately if contaminated or degraded

Oil standard: Do not mix different brands; same brand oils with different viscosities may be mixed if necessary

Operating temperature range: -40℃ to +40℃

Below 0℃: preheat oil above 0℃ or use low pour point oil before startup

Oil Level Inspection Procedure

Disconnect power and ensure the system is cooled

Unscrew oil level plug and check oil level

Reinstall plug after confirmation

Oil Condition Testing

Take oil sample from drain plug

If oil appears cloudy or abnormal, replace it immediately

Ensure oil level remains within the specified range

Oil Replacement Procedure

Change oil while still warm for better drainage

Place oil container under drain plug

Open oil level plug, vent plug, and drain plug

Fully drain old oil

Reinstall drain plug

Fill with new oil of the same brand

Check oil level through inspection port

Tighten all plugs and vents securely

2. Regular Inspection and Replacement of Wear Parts

Internal components of the reducer are subject to continuous high-load operation and should be inspected regularly.

Key Wear Parts:

1) Gears

Gears are the core transmission components. Operating at high speed and load, they are prone to wear. Regular inspection is required to detect damage early and ensure stable torque transmission.

2) Oil Seals

High operating temperatures may cause deformation and leakage. Any oil leakage should be addressed immediately by replacing seals and restoring proper oil levels.

3) Bearings

Bearings operate under high-speed rotation and are vulnerable to fatigue damage. Abnormal noise or vibration should be investigated immediately, and damaged bearings must be replaced.

3. Important Maintenance Notes

Do not strike the reducer housing to avoid structural damage

Regularly inspect mounting base, seals, and drive shafts

Normal oil temperature should remain below 85℃

Stop operation immediately if abnormal temperature rise or noise occurs

After replacing key components, perform break-in and load testing before full operation

Noticias