The crawler square-rod LQR154 line lists four models, with maximum drilling depth running from 10 m to 17 m. Lay the four spec sheets side by side and every row is identical except depth, operating weight and transport dimensions.
Start with what is shared. All four list a drilling diameter of 500-2000 mm, a rated output torque of 17/30 kN·m and a rotation speed of 20 rpm. The upper limit on hole size and the torque steps are one set of figures for the whole series.
Crowd and lift match as well: 100 kN crowd force, 120 kN line pull and 30 MPa working pressure. The four models carry the same crowd and pull-up arrangement rather than scaling it up with depth.
The undercarriage is common too: 110/118 kW engine power, China Stage III emission, 450 mm track shoe width, 3,600 mm total track length, 5 km/h travel speed, 30° gradeability and 360° swing.
The first real difference is maximum drilling depth: 10 m on the -11, 12 m on the -13, 14 m on the -15 and 17 m on the -18. That figure sets the pile length the machine can reach, and it is the easiest row to misread.
The second difference is operating weight: 11.5 t, 12 t, 12.5 t and 13 t. Going from 10 m to 17 m adds 7 m of depth but only 1.5 t of machine, so the whole series spans 1.5 t.
Read from the sheet, the most direct correspondence for that 1.5 t is a longer mast and kelly rather than more power, since engine output is identical across the four. The table does not break the figure down by component, so this stops where the data does.
The third difference is transport dimensions, and it is the one most often skipped at selection. The sheet gives three figures without labelling the axes; read as length x width x height, width is 2,250 mm on all four and length is 7,500 mm, 8,500 mm, 9,500 mm and 8,500 mm.
Transport height comes in two steps: 2,800 mm on the -11, -13 and -15, and 3,100 mm on the -18. Read the same way, the 17 m machine rides 300 mm taller than the other three, so check overhead clearance before it arrives.
Put those three groups back into a working condition and the order becomes clear. If pile depth sits around 10 m and the access route is tight, the -11 needs only 7,500 mm of transport length, the shortest of the four, and is the easiest to move in and out.
For 12 m to 14 m, choose the -13 or the -15: 1,000 mm apart in transport length and 0.5 t in weight. The trade at this step is not hole capacity but whether the site can take the extra metre of machine.
For 17 m, only the -18 covers it. Its transport envelope is 8,500 mm x 2,250 mm x 3,100 mm, 1,000 mm shorter and 300 mm taller than the -15, so a wide but height-limited route needs recalculating.
The cover photo shows a square-rod rig in the factory yard: teal body, crawler undercarriage flat on the concrete, cab to the right of the mast, the mast fully raised with its top near the upper edge of the frame, office block with red signage behind.
What the sheets cannot answer should be said plainly: ground conditions, penetration rate and which tool to fit are not written in these four tables, and nothing is inferred here. Selection by strata needs item-by-item confirmation with the manufacturer.
So the order can be reversed: fix the maximum pile depth first, then measure the width, height and turning space of the access route, and finally check whether 500-2000 mm of diameter and 17/30 kN·m of torque cover your pile type. All three steps use figures that are already on the sheet.