Put the LQR130 and LQR130S spec sheets side by side and the overlap is striking: both reach a maximum drilling diameter of 1,500 mm, both drill to 30 m, both run the same Cummins 154 kW engine. What can be verified as different comes down to two items.
Start with what is identical. Both list a maximum drilling diameter of 1,500 mm, a maximum depth of 30 m, a Cummins 154 kW engine and a power-head working speed of 5-40 r/min.
Crowd and winches match as well: 120 kN supporting force, 120 kN line pull and a 2,500 mm stroke; main winch 150 kN with 24 mm rope at 30 m/min; auxiliary winch 30 kN with 12 mm rope at 55 m/min.
Mast inclination is listed the same on both: 4 degrees laterally, 5 and 90 degrees fore and aft. Hole capacity, lifting capacity and mast movement are identical on paper.
The first difference sits in the undercarriage. The LQR130 lists a fixed track extension width of 3,000 mm; the LQR130S lists 3,000-4,000 mm, so its gauge can be set from three to four metres while the LQR130 stays at three.
The second difference is operating weight: 28 t against 31 t, three tonnes apart, about 10.7 percent of the lighter machine. It is the only figure tied directly to what the extra equipment costs.
The judgement those two rows support is straightforward: a frame that extends to four metres has to be built for a larger bending moment, and that mass ends up in the total weight.
The direct result visible in the numbers is support width. Fully extended, the lateral base goes from 3,000 mm to 4,000 mm, one metre wider, a third more than the fixed setting of three metres.
Note what does not change: both list shipping dimensions of 11,800 x 3,000 x 3,550 mm. The extra metre is opened up on site rather than carried on the road, so transport width stays as it was.
Track shoe width of 600 mm and total track length of 4,550 mm are also identical. What changes is the span between the two tracks, not the contact area or the ground pressure.
Where does that matter? Where the pile diameter regularly runs near the 1,500 mm ceiling, where pile positions fall on backfill or soft ground, or where more margin against tipping is wanted while slewing, spreading the tracks to 4,000 mm is the most direct step.
In the other direction, if the access route is a permanent three metres, if pile positions are scattered, or if the machine moves several times a day, the fixed 3,000 mm frame on the LQR130 is simpler: no room to reserve for extension and three tonnes less to carry.
One boundary should be stated. The sheets give total weight and extension width only; they do not split the three tonnes between counterweight and track frame. That breakdown has to come from the factory, and nothing here guesses at it.
So the choice compresses into one question: does your pile diameter sit near the 1,500 mm limit often? If it does, three tonnes buys a metre of gauge. If it does not, the fixed frame is enough.