LQR130 vs LQR150: Choosing by Drilling Depth and Weight

The LQR130 and LQR150 sit on the same crawler, interlocking Kelly bar line. Both reach a 1500 mm maximum bore diameter, and both use the same chassis and rod type. The differences come down to two numbers, and this article covers only what the parameter tables can prove.

Set the two side by side. The LQR130: 1500 mm bore diameter, 30 m maximum drilling depth, 28 t operating weight. The LQR150: 1500 mm bore diameter, 40 m maximum drilling depth, 42 t operating weight.

The first difference is depth: 30 m against 40 m, a gap of 10 m — one third of what the LQR130 can reach.

The second is operating weight: 28 t against 42 t, a gap of 14 t, exactly half the LQR130’s own weight.

The two numbers are not independent. A deeper hole calls for a longer rod, more winch stroke and a stronger rotary drive to support it, and all of that ends up in the operating weight: on the parameters, the extra 10 m of depth costs 50% more machine weight.

First question: will the pile exceed 30 m? While the usual pile length stays within 30 m, neither machine is limited by depth. Once the pile moves into the 35–40 m range, the LQR130 is beyond its range and the LQR150 is the only option of the two.

Second question: can the site and the haul accept 42 t? Operating weight drives the transport and lifting plan directly, and 28 t and 42 t are jobs of two different magnitudes.

Third question: if the pile length is settled within 30 m, the lighter machine leaves more margin on soft ground, on backfilled sites, and on jobs where the rig has to move often.

That both machines share a 1500 mm bore diameter matters: a diameter filter cannot separate them, so the decision falls entirely on pile length and ground bearing capacity.

One model in the same series is easy to confuse. The LQR130S shares the LQR130’s 1500 mm bore diameter and 30 m depth but weighs 31 t. Same diameter, same depth, 3 t more — the two configurations differ, and which items differ should be confirmed item by item against the technical agreement rather than inferred from the model suffix.

If the diameter requirement is smaller, lighter options exist: the LQR100 at 1500 mm / 20 m / 23.5 t, and the LQR-80 at 1500 mm / 15 m / 15.5 t.

Where the rig must move often between scattered sites, wheeled models keep the same 1500 mm bore at just 16–17 t: the LQR360 and the LQR-100W are both 1500 mm / 20 m. The lighter LQ180 series runs 8–9 t with drilling depths covering 10–19 m.

For harder strata that demand more output torque, the answer lies on another line: the CFA long auger LQR-260C is rated at 260 kN·m with a 30 m drilling depth, while the LQR180C is 1000 mm / 25 m / 47 t.

The trade-off in one line: settle the pile length first. Above 30 m, go straight to the LQR150. Within 30 m, compare weight — where the choice falls between 28 t and 42 t, taking the lighter machine simplifies both haulage and site work.

One reminder: operating weight also drives lifting and low-bed trailer arrangements. Before signing, check transport dimensions, the lifting plan and site bearing capacity together rather than comparing drilling depth alone.

The figures above are taken from the parameter tables for each model. Different configurations will produce different values, and the signed technical agreement governs. If you have a specific pile diameter and length, send us the working conditions and we will suggest the matching model.

News